|Email Newsletters from Pharmaceutical Technology and Pharmaceutical Technology Europe|
News from Europe's pharmaceutical manufacturing industry coupled with upcoming events, and exclusive articles and interviews from industry experts.
Designing a Clean-in-Place System
Clean-in-place (CIP) technologies improve cleaning processes and increase critical equipment uptime. An efficient cleaning cycle begins with equipment and automation systems designed to ensure successful cleaning.
The next step in the cleanability review is to create a preliminary design of flow paths for CIP circuits. Segments of equipment and piping should be properly separated and/or combined into different cleaning circuits as part of a preliminary design. Important considerations include process and schedule requirements, potential residues, and piping design.
Process and schedule. Knowledge of the equipment’s use can provide insight on process hold or transfer times. Transfer lines and tanks may need to be chained together into a single CIP circuit for quick equipment turnaround to meet these demands. Clean and dirty hold times may also affect equipment scheduling and cleaning requirements.
Residues. Characterizing residues through cleaning studies and identifying associated product-contact surfaces aid in parameter development. Certain residues may require different cleaning solutions, concentrations, and temperatures for suitable cleaning to occur. This analysis can help organize circuits by common cleaning parameters.
Piping design. Available transfer panel connections may limit the combination of certain transfer lines and tanks. The user should account for line sizes and lengths as major pressure drops may decrease flow and turbulence within the pipe. Additional pumps and other spool pieces may be required within the system. Caution should be exercised in these cases to minimize manual configuration steps and reduce the risk of setup errors. Finally, the user should consider the availability of low-point gravity drains throughout the CIP circuit. Gravity drains remain critical for efficient CIP cycles.
Various time and cost-reducing methods must be balanced with skid equipment capability. For example, one may be able to take advantage of integrated PLC capabilities of equipment (e.g., vendor-provided PLC-based centrifuges). These design considerations must be identified early in the project to ensure that quality and validation procedures can be developed to address the sampling, instrumentation, and verification requirements being built into the CIP and recipient systems.
For the CIP cycle itself, the automated step sequencing, step-transition criteria, and parameter values must be well defined and documented to optimize utility usage while providing sufficient process control.
Sequence. Typically, a cleaning cycle should start with water rinses followed by detergent cleaning and post-detergent rinses. In between any rinse or detergent wash, the system should be drained completely to prevent dilution or chemical reaction with the next cycle step. An air-blow step, placed before the drain, can greatly decrease the gravity drain time and thus decrease the overall cycle time.
Transition criteria. Defining step-transition criteria provides a way to control the critical cleaning-cycle parameters. For example, the chemical-wash duration, minimum temperature set point, and concentration target can all be set as requirements before the wash step transitions to the next step.
Parameter values. Laboratory-scale process residue cleaning studies can provide an excellent starting point for CIP cycle parameters. Scalable attributes such as cleaning-agent concentration, process temperature, exposure time, and external energy can be explored within the cleaning design space to isolate the most critical parameter(s). Combined with an evaluation of the most effective cleaning agent and identification of worst-case residues in the process, these laboratory-scale efforts can dramatically reduce the number of cycle iterations that must be performed during commissioning and allow for a focus on improving efficiency.
Andrew Wong and Cody Shrader are senior engineers at Hyde Engineering + Consulting, Boulder, CO, Andrew.Wong@Hyde-EC.com.