Thorsten Schmeller is Head of Global Marketing New Products at BASF.
|
The main drivers for innovation in film coatings in the last 5 years mainly relate to optimising the film coating process
itself, as well as to the need for film coating materials with enhanced functionality. As such, new products have been developed
to make coating processes more efficient by reducing coating times, defect rates and the time needed for product development
and scale-up operations. Coating polymers with a low viscosity are particularly suited to meet these needs. A low viscosity
allows a higher solids content; the higher the solids content, the less time required to achieve the target coating level.
Beyond that, higher flexibility of the coating polymer reduces defect rates; for example, if the tablet core swells due to
water absorption during storage, a flexible film will adapt easily without cracking, helping to reduce the defect rates.
The majority of new product developments focus on ready-to-use coloured coating systems because of their convenience, simplicity
and cost synergies in the supply chain. Coating systems combine an optimised coating formulation driven by the polymer properties
with a consistent colour quality. This approach also leads to a reduction of weighing steps compared with single raw materials.
Coating systems show great benefits over single raw materials and are therefore of interest for the industry.
The pharma industry has also actively been asking coating manufacturers for support regarding optimisation of the supply chain.
The industry currently offers two different approaches for coating systems: pre-formulated, colour-specific coating systems,
which require storage space and logistics for each colour. The second and unique approach offered by BASF is to use coating
systems based on a base colour concept, where the colour is created on-site out of seven base colours. The advantages here
are reduced efforts in incoming raw material control and logistics.
Industry challenges
One particular challenge in the industry is obtaining adequately uniform films. Coating conditions, in general, are determined
by the type of technical equipment used for the coating process. The amount of coating materials applied is a direct result
of the number of spray gun passages; the more often the tablet passes the spray gun, the more uniform the tablet will be covered
with coating material. Further to that, the coating suspension must have the ability to nicely spread out on the tablet surface.
In terms of functionality, the industry is also looking for solutions regarding formulation issues, such as taste masking.
The masking of unpleasant tastes, which a lot of APIs have, has gained importance with the trend towards modern dosage forms,
such as ODTs, and the need to develop paediatric medicines. Conventional film coating material often cannot solve this issue
of taste, but there are two approaches that coating manufacturers can use. Firstly a combination of standard excipients may
lead to synergy effects and might solve the issue. In many cases, however, new and improved functional polymers are the only
solution to overcome the challenge, a number of which are currently in development.
